Check how axis respond in windows control panel/game controllers or better so in DIVIEW software. Check that axis respond from 0 to 100% in MFG Configurator.if not then FOLLOW OTHER FAQ and calibrate axis inside MFG Configurator.this must be addressed first !Ģ. When you have a problem like this it need to be addressed from root hardware to the sim to determine the cause !ġ.
Replacement instructions are described ( and in video) on cable product page ! Brake axis often loose calibration and need to be recalibrated Sometimes it's just a poor contact between cable and electronics so it is important to make a proper conclusion before you jump on replacement cable, as replacement take a bit of time and patience.Ĭable can be bought in our shop at accesorries section, but take care to buy correct one for your pedals (V1 or V2). Of course, if your signal is already at 0 or 100% and it spikes BACK to normal when you wooble the cable it's also a faulty cable. If you see the signal suddenly spike to 0% or 100% than its likely that you have faulty cable and need to replace it.
Getting flightgear rudder to work software#
Shake / wooble faulty brake axis cable near the connector and watch the signal while doing so ( DIVIEW software is more handy to watch signal). and use contact spreay if you have one.Ģ. In any case.blow off your contacts and test again. In this step you determine what is to blame - cable or electronics. IF problem is in the cable it will follow cable now and change axis.but if electronics have issue the problem WILL STAY on same axis regardless of cable being swapped. In essence your left brake will now become Y axis, and right brake will be X axis. Swap left and right brake cable connection to main electronics. In fact, it should NEVER reach 0 or 100% signal on axis.
Getting flightgear rudder to work full#
In this mode you will have a working signal regardless of angle adjusted and calibration, troughout the range.but it will not be full from 0 to 100%.
This is basically sensor inspection mode. You can inspect brake axis by turning off (untick) autocalibration ON/OFF feature on X and Y axis and click apply. This happen very rarely so make sure you read all other brake axis FAQ topics first !
0 kommentar(er)
